Hot Water Generators

Hot Water Generators

Relying on our wide experience and knowledge in this sector, we are counted amongst the top most and reputed manufacturers and suppliers of Hot Water Generators. Our whole gamut is manufactured as per market standards by utilizing optimum quality raw materials and advanced technology. These generators find their usage to heat water in dairies, hotels, hospitals, laundries, restaurants and hostels. Hot Water Generators offered by our company are widely appreciated due to their robust construction, impeccable performance, long operational life and corrosion and rust proof surface finish.     

Specifications

Complete with electrical panel consisting of Switchgear and controls like relief valve, low water level cut-off, High temperature cut-off etc

VESSEL CONSTRUCTION
Vessel of the Hot Water Generator is made out of M.S. sheet as per IS 2062 GR-A, 6 mm to 12 mm thick shell and 8mm to 12mm thick dish ends with top open able according to the size of Generator. Vessel is spray galvanized from inside to avoid corrosion and SS lining is also done on request at extra cost.

WATER LINE CONNECTION
2” to 8” Diapipes with flanged end connection according to the size/ Capacity of the Generator.

HEATING ELEMENT
Own make Electrical immersion heaters and also use other makes on request at extra cost.

ELECTRICAL PANEL
Made from 16 gauge sheet provided with MCCB/SFU, bus bar, outgoing contactors with HRC fuses, push buttons, lamps on each step with digital step controller Automatic alarm and cut - off for low water level and high temperature, ammeter and voltmeter with selector switches. The control wiring is tested at factory to ensure the working of all the controls and switchgear satisfactory.

CAPACITY CONTROL
Capacity control of the Hot Water Generator is equally distributed in load. This is also divided from 1 to 8 steps according the capacity.

CONTROLS
Digital thermometer, 100mm dia. pressure gauges with ball valves, thermostat, relief valve, alarm with indication lights.

PRESSURE TEST
The Vessel of the Hot water generator is tested at the 250 PSI. And hold the pressure for 24 hours.

INSULATION
With 50 to100mm thick fibre glass and cladding with 0.8 to 1.5 mm aluminium sheet or G.I sheet as per the requirement of the client.